BatteryMINDer 128CEC2-AA-S2 12V 8 Amp GILL Aviation Battery Charger-Maintainer-Desulfator

The BatteryMINDer 128CEC2-AA-S2 12V 8 Amp GILL Aviation Battery Charger-Maintainer-Desulfator maintains and charges all 12V GILL sealed or wet cell aviation batteries. The 128CEC2-AA-S2 will determine the level of charge remaining in your battery, and if the battery is weak and needs to be replaced.

• Works with all GILL G-series batteries, including LT 7000 series.
• Tests for weak/dead battery cells and will recover weak or discharged batteries that other chargers would not.
• Highly efficient design with industrially-rated microprocessors allow continuous 24/7 operation.
• Temperature sensors prevent overcharging or undercharging from freezing to 130-degrees F conditions.
• Pulse-type desulfation keeps battery free of sulfate or dissolves sulfate in older batteries.
• Automatically detects and rejects bad cell batteries.
• Maximizes battery life and capacity.
• Diagnoses battery condition and state of charge.
• Recovers weak or discharged batteries, including flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.
• Rugged, vibration-resistant design.
• Maintains up to 2 batteries at a time (requires part 210-AY, sold separately).
• Automatically restarts after a power outage.
• Includes short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.
• Automatically detects input AC power.
• Eco-mode with high-efficiency, low power consumption.
• Includes (1) 128CEC2-AA-S2 charger-maintainer-desulfator, (1) 6′ AC cord, (1) 6′ DC cord with quick connector (SAE), (1) auto-temp compensation sensor (pre-installed), and (1) 2′ insulated battery clip cord set with quick connector and 15A replaceable fuse.
• Voltage: 12V.
• Charging Current: 8 amps.
• Power Source: 90-140 VAC, 47-63 Hz.
• Temperature Compensation: -4°F (-20°C) to 122°F (50°C).
• IP65 protection: Dust tight: No ingress of dust; complete protection against contact (dust tight). Protection from water projected by a nozzle (6.3 mm) against enclosure from any direction shall have no harmful effects.
• Dimensions: 4.9″ length x 7.3″ width x 2.1″ height.
• Weight: 3 lbs.